Bucyrus 495B Electric Mining Shovel Operators Manual BI616753
Bucyrus 495B Electric Mining Shovel Operators Manual BI616753 - Image 2
Bucyrus 495B Electric Mining Shovel Operators Manual BI616753 - Image 3
Bucyrus 495B Electric Mining Shovel Operators Manual BI616753 - Image 4
Bucyrus 495B Electric Mining Shovel Operators Manual BI616753 - Image 5

Bucyrus 495B Electric Mining Shovel Operators Manual BI616753

$30.00

  • Type Of Manual: Operators Manual
  • Manual ID: BI616753
  • Number of Pages: 46
  • Size: 2.9MB
  • Format: PDF
Category:

Product details

  • Model List:

    • 495B Electric Mining Shovel
  • 1. COVER PAGE
  • 2. FOREWORD
  • 3. SAFETY DECALS
  • 4. TABLE OF CONTENTS
  • 5. SAFETY PRECAUTIONS AND PRESTART CHECKS
  • 5.1. GENERAL
  • 5.2. SPECIFIC SAFETY RULES
  • 5.3. OPERATION NEAR ELECTRICAL DISTRIBUTION AND TRANSMISSION LINES
  • 5.4. PRESTART CHECKS
  • 5.4.1. GROUND LEVEL WALK-AROUND INSPECTION
  • 5.4.2. ON-BOARD INSPECTION
  • 5.5. LUBRICATION CHARTS
  • 6. CONTROLS – FUNCTION AND LOCATION
  • 6.1. INTRODUCTION
  • 6.2. PRIMARY OPERATING CONTROLS
  • 6.2.1. HOIST/SWING/PROPEL MASTER SWITCH (LEVER)
  • 6.2.2. SIGNAL HORN LEVER
  • 6.2.3. CROWD/HORN/DIPPER TRIP MASTER SWITCH (LEVER)
  • 6.2.4. DIPPER TRIP LEVER
  • 6.2.5. HOIST BRAKE SWITCH
  • 6.2.6. CROWD BRAKE SWITCH
  • 6.2.7. SWING BRAKE SWITCH
  • 6.2.8. PROPEL BRAKE SWITCH
  • 6.2.9. PROPEL STEERING SWITCH
  • 6.2.10. AIR PRESSURE GUAGE
  • 6.2.11. CONTROL RESET PUSHBUTTON
  • 6.2.12. PROPEL TRANSFER SWITCH
  • 6.2.13. CONTROL STOP PUSHBUTTON
  • 6.2.14. MACHINE STOP/EMERGENCY STOP PUSHBUTTON
  • 6.2.15. MAIN POWER OFF PUSHBUTTON
  • 6.2.16. PANELVIEW MONITOR
  • 6.2.17. WINDSHIELD WIPER SWITCHES
  • 6.2.18. WINDSHIELD WASHER SWITCH
  • 6.2.19. CABLE REEL ON/OFF SWITCH (OPTIONAL)
  • 6.2.20. OPERATORS SEAT
  • 6.2.21. AIR CONDITIONER SWITCHES
  • 6.2.22. CAB LIGHT SWITCH AND ELECTRICAL OUTLET
  • 6.2.23. UPPER WINDSHIELD WIPER
  • 6.2.24. LOWER WINDSHIELD WIPER
  • 6.2.25. WINDSHIELD WASHER SPRAY NOZZLES
  • 6.2.26. CIGAR LIGHTER
  • 6.2.27. OILERS SEAT
  • 6.2.28. FIRE EXTINGUISHER
  • 6.3. SECONDARY OPERATING CONTROLS
  • 6.3.1. PLC CABINET
  • 6.3.1.1. CONTROL STOP PUSHBUTTON
  • 6.3.1.2. EMERGENCY STOP/POWER OFF PUSHBUTTON
  • 6.3.2. AC CONTROL CABINET
  • 6.3.3. REMOTE START CONSOLE
  • 6.3.3.1. EMERGENCYY STOP/POWER OFF PUSHBUTTON
  • 6.3.3.2. AIR COMPRESSOR RUN SWITCH
  • 6.3.3.3. MACHINE STOP PUSHBUTTON
  • 6.3.3.4. SYSTEM RUN PUSHBUTTON
  • 6.3.3.5. UNINTERRUPTABLE POWER SUPPLY OFF PUSHBUTTON
  • 6.3.3.6. UNINTERRUPTABLE POWER SUPPLY START PUSHBUTTON
  • 6.3.3.7. INCOMPLETE SEQUENCE LIGHT
  • 6.3.3.8. AUXILARY GROUND FAULT LIGHT
  • 6.3.3.9. PHASE SEQUENCE LIGHT
  • 6.3.3.10. PLC CABINET TEMPERATURE LIGHT
  • 6.3.3.11. DRIVE CABINET TEMPERATURE LIGHT
  • 6.3.3.12. PLC POWER ON LIGHT
  • 6.3.3.13. SYSTEM READY LIGHT
  • 6.3.4. UPS CONTROL BOX
  • 6.3.5. LIGHT CIRCUIT BREAKERS
  • 6.3.6. LIGHTING TRANSFER SWITCH (OPTIONAL)
  • 6.3.7. CABLE REEL START/STOP PUSHBUTTONS
  • 7. STARTUP, OPERATION, AND SHUTDOWN
  • 7.1. START UP
  • 7.2. OPERATION
  • 7.2.1. HOIST MOTION
  • 7.2.2. CROWD MOTION
  • 7.2.3. SWING MOTION
  • 7.2.4. PROPEL MOTION
  • 7.2.5. STEERING
  • 7.2.6. CABLE REEL OPERATION
  • 7.2.7. POSITIONING MACHINE AT BANK
  • 7.2.7.1. BACK-UP METHOD
  • 7.2.7.2. DRIVE-BY METHOD
  • 7.2.8. START OF DIG CYCLE
  • 7.2.9. ENGAGING THE BANK
  • 7.2.10. PROPER SWING MOTION
  • 7.2.11. MATERIAL EXCAVATED
  • 7.2.12. OPERATING HINTS
  • 7.2.13. DURING OPERATION – CHECKS
  • 7.2.14. STOPPING THE MACHINE
  • 7.3. SHUTDOWN
Rate this product

Related products